When running a batch
I have an existing file open and then an action which opens a pre exisiting file that i Drop images into to give boarders and logos.
When I run the action it drops image into the PSD in the correct area and the file looks correct , then in turn it saves the Original file and not the one the batch ran on even thou the file was worked on and edited on CS6. So in a sense it saves the Original File with the correct File naming when ran in the Batch Image processor.
Original file Name.
OUT_9035.NEF
Saved File name
OUT_9035-12x18-2013.PSD
Still with nothing done to the saved file execpt the name change.
Action
Open
C:\*****\12x18-W.psd
Select Previous Document
Duplicate Current Layer
to Document 12x18-W.psd ]
Name "Background"
Select Next Document
Transform Current Layer
Center : Center
Translate: -0.01 Inches , 0.165
Width 115.4%
Height 115.4%
Interpolation : Bicubic
Thank you for your time.
~far